Concentric Flue System LAS Basis Set 1 Roof with 33-45°

Flue Tube concentric for roofs with 33-45 °

Concentric smoke pipe set
Smoke pipe / exhaust pipe
Diameter: 100/150 mm
Dimensions: see picture
Glossy stainless steel finish

Indoor air-independent gas fireplace inserts from Brunner must (may only) be installed with the air exhaust system (LAS) from Brunner.

Hints:
For the professional planning of flue gas systems, in particular of combustion systems for gaseous fuels, in addition to the specifications listed below, the projects and
The provisions of the respective state building regulations, combustion regulations and TRGI must be observed.

- Wall or rafter fastenings: at least every 4.0 m.
- Cantilever system end: maximum 2.0 m.
- Opening over the roof / opening on the facade: The local and state-specific regulations, as well as minimum distances to windows and openings, must be observed.
- Clamp band: Each pipe joint requires a clamp band - is included in the scope of delivery.

Technical data for stainless steel air exhaust systems:
Design: Concentric exhaust pipes
Operating mode: negative pressure, dry
Exhaust gas temperature max .: 450 ° C
Fuel: gas
Application: Fireplaces independent of ambient air (class C 11 and C 31, as well as C 91 up to the flexible pipe in the shaft), testing and CE marking in each case together with the gas appliance.

Set of components:

• 1x adapter with clamping band (LAS 100/150)
• 1x measuring element 200 mm with clamping band (LAS 100/150)
• 1x inspection element 300 mm with clamping band (LAS 100/150)
• 1x length element 1000 mm with clamping band (LAS 100/150)
• 1x Muzzle seal Terminal Multivent vertical (LAS 100/150)
• 1x roof duct 33-45 ° with aluminum flex edge and weather collar
• 1x ceiling panel in two parts, sloping roof 31 °
• 1x rafter bracket
• 1x tube of lubricant 75 ml

General remarks:
We recommend clarifying the exhaust system in advance with the responsible chimney sweep. Different regulations and guidelines in the respective federal states make this essential.
Each additionally installed pipe element is taken into account with a deduction of 0.06 m in the length determination (socket connection).
Position of the measuring element: directly on the connection adapter on the exhaust outlet.
Additional length elements in the Y-section or in the X-section before the reduction must be 30130/200 mm.
Second cleaning opening in section X1 required if X1> 1m